Schumacher 1/10 2WD Cut Stagger Front Slim Wheel And Tyres Yellow Bearing Fit (Pack Of 2) - U6760

SCHUMACHER 108T x 3.0mm MBL Belt FT8

3.5 x 1 'O'ring (pk10) - Mi9

SCHUMACHER 5 x 1 `O`ring (pk10)

6 x 1 'O'ring pk10 - Mi7,Icon/2,E4,Mi8,E5,A3,FT8

DIFF SPACER SET - A2/3,E4/5,ICON/2

SCHUMACHER Alloy ARB Drop Link - Mi8,FT8,Mi9 (pr)

SCHUMACHER Alloy Centre Track Rod Assy - Mi7,Mi8,Mi9

Alloy chassis for the Mi8 HGT and Mi9

This chassis is suitable if you have already purchased the HGT C/F kit in the past. (U8562)

(This chassis will not fit a standard Mi8 without the HGT conversion)

Suitable for medium to high grip carpet racing.

This differential/spool eccentric allows you to adjust the height of the diff/spool to a new 'High' position compared to the standard kit 'Low' position. 

The smart looking piece as normal is used to adjust the belt tension, as well as being able to fine tune the feeling of the car.

Normally a higher front spool smooths the steering response compared to the standard low kit setting.

A higher rear diff can give the car more drive out of the turns keeping it flatter.  A low standard position normally gives a little more side bite.

A worthwhile item to have available to tune your Mi7 to different track conditions. 

ALLOY HUB CARRIER - MI9 (PR)

ALLOY HUB CARRIER PR - E3-E5

SCHUMACHER Alloy Layshaft Pulley - Mi8,Mi9

SCHUMACHER-Alloy-LiPo-Mount-pr-Mi7,FT,Mi8,FT8,Mi9

SCHUMACHER Alloy LiPo Swivel - Mi8,L1R,FT8,ST2,LD3,Mi9 (pr)
Bling up your car with this cool looking black alloy LiPo swivel.

Increased strength over kit item.

When combined with U8438 Alloy Lipo Mounts - LD2 (pr) we suggest using a plastic LiPo swivel or a plastic height adjustment washer when using these as an insulator from short circuit.

ALLOY PIVOT BLOCK - A2,E3-E5,ICON/2

ALLOY PIVOT MOUNT - A2,E3-E5,ICON/2

ALLOY RADIUS ARMS - MI7,MI8 (PR)

ALLOY REAR BLOCK SPACER 1MM - CAT L1

SCHUMACHER Alloy Shock Top Ball - Mi8,FT8,Mi9 (pr)
A slicker solution for mounting the shock tops to the shock tower.

Just 1 screw with a locating pip into the other holes in the tower.