- NEW* 80A brushed speed controller withT-connector and 540 motor
- NEW* Programmable speed controller
- NEW* 15kg steering servo with metal gears
- NEW* LED lighting
- NEW* Race body with many add-on parts
- NEW* even more option parts available
The new 80A Brushed speed controller is waterproof, programmable and pre-configured with a T-connector. To fully exploit the potential of the vehicle, we recommend a 2S LiPo battery for operation. In addition, a separately available programming card (item 2110061) can be used to set various parameters such as braking force, punch, low voltage protection and more.
The car is powered by a 540size 15T brushed motor that directly accesses the all-wheel drive system. The two differentials (front and rear) are driven by an aluminum driveshaft.
Due to the higher power of the speed controller and the use of T-connectors, any 2S LiPo battery can be used - no matter what the C-rate and capacity.
4 oil-pressure shock absorbers provide ideal handling, so there is plenty of driving fun. A 15kg metal gear servo with takes over the implementation of the steering commands.
Lightweight and compact design, as well as comfortable and ergonomically shaped - these are just two features of our CR4S 4-channel remote control. Of course, all trim, reverse and dual rate functions are available in the cockpit, making adjustments easy via levers and knobs. In addition, the remote control has a "Beginner Mode" (speed reduction by 50%) and is therefore ideal for pilots who do not yet have so much experience with the handling of such RC vehicles.
- 4WD all wheel drive
- 2.4 GHz 4-channel radio system
- 80A brushed speed controller with T-plug
- 540size 15T motor with 32.000RPM @ 7.4V
- 15kg MG steering servo (25T, ball bearings)
- Oil shock absorbers
- Ball bearing main drive
- Extremely durable composite plastic parts
- Steel differential outputs
- Aluminum main drive shaft with steel mounts
- Adjustable upper tie rods
- 5mm aluminum motor mount
- 6mm shock towers
- 2 differentials (front/rear)
- Stylish truggy body with add-on parts
- "Light-Weight" chassis (less weight - longer drive time)
- Many aluminum option parts available
- Scale: 1:10
- Dimensions (L/W/H): 405x325x165 mm
- Weight: 1740g
- Wheelbase: 270mm
- Ground clearance: ca. 35mm
- Track width: 270mm front/rear
- Wheels front/rear: Ø 105mm / Width: 55mm
- Shock absorber oil: 400CPS
- Shock absorber installation length: 90mm
- Motor ratio: pinion: 18T / main gear: 64T (module 0,6)
- 1/10 Truggy "AT3.4V2" RTR
- 2.4GHz "CR4S" radio
- Sticker sheet
- Manual
